Peugeot 308: Re-programming of the function : Powered tailgate

1. Programming of the minimum and maximum angles of the tailgate in the tailgate motorisation system

The motorisation system is supplied in disengaged configuration, the tailgate can be moved by hand during fitting.

The electronic unit (BEVM) is supplied awaiting programming : No motorisation is possible until the programming operation has been carried out correctly.

CAUTION : If the electronic unit (BEVM) has already been used : The electronic unit (BEVM) must be cleared before being programmed.

When the motorisation system is connected to the battery and to the CAN (BSI with complete software and not with fitting software) : With the safety auto-reverse sensors and the closing button connected to the motorisation system, the striker, the lock and the opening button must be fitted and connected to the electrical network.

Lock the tailgate with the lock closed on the striker (striker in the in position).

After 3 seconds in this state, the "tailgate closed" position is programmed : The electronic unit (BEVM) then emits a short bleep.

Press the opening button (Near the number plate).

Allow the tailgate to open without hindering it (the tailgate will move to the maximum opening position).

The "tailgate open" position is programmed : The electronic unit (BEVM) then emits a short bleep.

The system is initialised and can be used normally.

N.B. : The programming is retained even if the battery is disconnected.

2. Clearing the programming for re-programming

Use the repair menus of the tool DiagBox to clear the programming of the powered tailgate.

Replacement : High frequency remote control/hands-free identifier batteryPainting : Tailgate (Excluding sheet metal )